|
Installation - Download the appropriate WANPIPE Release based on the Sangoma Hardware. Refer to the Wanpipe Drivers section.
- Untar the wanpipe release in the arbitrary directory (/usr/src/) and hwec-utils is you have a hardware echo canceller.
tar xvfz wanpipe(version)
After untarring WANPIPE, the wanpipe/ directory will be created.
- Run ./Setup install
Proceed with installation Select "Y" for each option.
Under the compilation mode: Select "TDM Only drivers" (Option #2).
The etup will ask you for location of the zaptel sources?
[By default Setup will look in /usr/src/zaptel]
Setup will ask you if you would like to add support for the Sangoma HW HDLC DCHAN PRI to Zaptel.
"Compile TDMV DCHAN Native HDLC Support (y/n)?"
Select "Y" to Enable HW HDLC on DCHAN PRI in Zaptel.
Note: This option will PATCH the ZAPTEL driver.
Therefore zaptel must be recompiled after ./Setup is complete.
Proceed to compile wanpipe drivers.
- Proceed with the Defaults for the rest of the compilation.
If any errors are encountered during the compilation of the utilities, click here for assistance.
Configuration
Run wanpipe configuration utility: /usr/sbin/wancfg
Hardware Setup (AFT): Select Hardware: Specify which AFT card installed from hardware probe.
After probing the hardware, wancfg screen should show you:
(in this example, an A104 card)
----------------------------
Card Type-------> A104
Physical Medium-> T1
----------------------------
Sepecify Line Type: T1 or E1
Default is T1 Default configuration is complete: Select <BACK>
Protocol Setup: Select Protocol: TDM VOICE
Configuration is complete: Select <BACK>
Interface Setup: Skip First two options and leave them default.
Select: SPAN Number: 1 - Unlimited
The SPAN usually starts with 1
This option binds HW Port to a particular SPAN.
Select: Override Asterisk Echo Enable (AFT101/2/3/4/4d)
Default: NO Setting this option to YES will DISABLE echo cancellation
for this particular span.
ie: ignore what is configured in zapata.conf,
then set this option to YES.
This is mainly used in switching applications where one SPAN needs echo
cancellation and others do not.
Select: DCHAN PRI Timeslot: (AFT101/2/3/4/4d) Hardware HDLC support for DCHAN PRI
Options:
0 : Disable Hardware HDLC on PRI timeslot.
24 : T1 Line DCHAN is usually on timeslot 24
Enable Hardware HDLC on PRI timeslot. Default 24
16 : E1 Line DHCAN is usually on timeslot 16
Enable Hardware HDLC on PRI timeslot. Default
Note: TDMV_DCHAN values are ALWAYS [0 | 24 | 16]
(Don't confuse this with the Asterisk configuration that uses values greater than 24/31 for the DCHAN specification).
Configuration is complete: Select <BACK> to Save and Exit
|
